Seakeeper 3 - Start-up Procedure


OPERATION
MANUAL
Product: Document #: Rev: Page:
SEAKEEPER 3 90379 1 6 of 10
Section 2: SYSTEM OPERATION


2.2 Start-up
1) Make sure high current and low current DC inputs to the gyro are turned on.
2) When the low DC power is turned on the Display will initialize and the Home screen will
appear.
To turn the Seakeeper on, press the On/Off button, the button will turn blue. The
progress bar will appear and indicate how soon the Seakeeper will be available for
stabilization. When the Seakeeper is initialized and up to minimum operating speed the
stabilize button will appear. At this point, the Seakeeper is available for stabilization.
3) When the Seakeeper reaches its maximum operating speed where maximum
stabilization is available, the progress bar will disappear and the Seakeeper is available
for maximum stabilization.