OPERATION
MANUAL
Product: Document #: Rev: Page:
SEAKEEPER 3 90379 1 5 of 8
Section 1: SYSTEM OVERVIEW
1.2 Display
The display shown below is the user interface to the Seakeeper 3 and should be mounted at the
primary helm station. It is used to start, operate, monitor and shutdown the Seakeeper. Sensors,
alarms and shutdowns are provided to allow unattended operation.
The display provides information in the event of an alarm. Alarms cause precession to stop and
the Seakeeper to start coasting down.
FIGURE 4 – OPERATOR DISPLAY
To Next Page
Loading...
