To Next PageTo Next Page
Need help?Do you have a question about the Sealey HI-VIS and is the answer not in the manual?
Ensure the jack is in sound condition and good working order, using genuine parts for repairs.
Locate jack in suitable, well-lit area; keep work area clean and free of materials.
Engage vehicle handbrake, switch off engine, chock wheels, and place wedges under vehicle wheels.
Use jack on level ground, check lifting points, and use suitable axle stands for support.
DO NOT exceed capacity, operate if damaged, allow movement, or use for supporting load.
Use correct hydraulic oil only, DO NOT adjust overload valve, store jack properly when not in use.
Highlights single-piece hydraulic unit, heavy base, twin piston Super Rocket Lift, and universal joint release.
Lists Model No., Capacity, Minimum/Maximum Saddle Height, Maximum Chassis Height, Length, and Weight.
Assemble the two-piece handle and secure it using the provided bolt, avoiding over-tightening.
Verify oil level with ram retracted; top up with Sealey hydraulic oil if necessary.
Set parking brake, chock wheels, position saddle under lifting point, and operate jack.
Ensure area beneath vehicle is clear, then SLOWLY open release valve to lower the jack.
Keep ram retracted, clean jack, oil pivoting sections, and check oil level and piston rod periodically.
Addresses problems like jack not lifting, lifting poorly, not holding load, or not lowering.
Recycle unwanted materials; drain and dispose of fluids and product according to local regulations.
Guaranteed for 12 months from purchase date; proof of purchase required for claims.
Ensure the jack is in sound condition and good working order, using genuine parts for repairs.
Locate jack in suitable, well-lit area; keep work area clean and free of materials.
Engage vehicle handbrake, switch off engine, chock wheels, and place wedges under vehicle wheels.
Use jack on level ground, check lifting points, and use suitable axle stands for support.
DO NOT exceed capacity, operate if damaged, allow movement, or use for supporting load.
Use correct hydraulic oil only, DO NOT adjust overload valve, store jack properly when not in use.
Highlights single-piece hydraulic unit, heavy base, twin piston Super Rocket Lift, and universal joint release.
Lists Model No., Capacity, Minimum/Maximum Saddle Height, Maximum Chassis Height, Length, and Weight.
Assemble the two-piece handle and secure it using the provided bolt, avoiding over-tightening.
Verify oil level with ram retracted; top up with Sealey hydraulic oil if necessary.
Set parking brake, chock wheels, position saddle under lifting point, and operate jack.
Ensure area beneath vehicle is clear, then SLOWLY open release valve to lower the jack.
Keep ram retracted, clean jack, oil pivoting sections, and check oil level and piston rod periodically.
Addresses problems like jack not lifting, lifting poorly, not holding load, or not lowering.
Recycle unwanted materials; drain and dispose of fluids and product according to local regulations.
Guaranteed for 12 months from purchase date; proof of purchase required for claims.
General
