Why is weld bead too narrow on Sealey SUPERMIG180.V3?
If you're getting a weld bead that's too narrow and raised with your Sealey Welding System, it could be because the weld current is too low, so increase the power and wire speed. Another reason could be that the weld speed is too high, so move the torch slower and weave a little more.
How to fix irregular weld bead on Sealey SUPERMIG180.V3 Welding System?
If you're getting an irregular weld bead with your Sealey Welding System, make sure you're holding the torch correctly, using the correct torch angle. Also, check the roller tension and adjust it as needed if the wire is weaving in the weld pool.
What if feed motor is not working on Sealey SUPERMIG180.V3 Welding System?
If the feed motor of your Sealey Welding System isn't working but the lamp is on, it could be that the gears are damaged or worn, requiring replacement. Alternatively, the motor itself might be defective and need replacement.
General| Welding Process | MIG/MAG |
|---|---|
| Input Voltage | 230V |
| Input Frequency | 50/60Hz |
| Rated Input Current | 16A |
| Welding Current | 30-180A |
| Max Output Current | 180A |
| Wire Diameter Range | 0.6-1.0mm |
| Wire Feed Speed | 2-16m/min |
| Cooling System | Fan cooled |
| Protection Class | IP21S |
| Duty Cycle | 60% @ 180A |
| Wire Capacity | 5kg |
| Gas Type | CO2, Argon, Mixed Gas |
Electrical safety precautions, RCD use, and cable checks.
General operating safety, PPE, and work area conditions.
Safe handling and storage of gas cylinders.
Overview of Supermig models and initial user guidance.
Technical details and performance data of the SUPERMIG180.V3.
Steps for assembling the gas platform and attaching wheels/castors.
Guide for mounting the gas cylinder and connecting the regulator.
Procedure for connecting the torch cable to the welder.
Instructions for installing both 5kg and 15kg welding wire reels.
Steps to feed welding wire from the spool through the torch.
Adjusting wire tension, clutch, and drive roller settings.
Understanding the MIG/MAG process and initial welding preparation.
Guidance on setting power output, wire speed, and voltage.
Advice for welding steel/aluminium and performing spot welding.
Understanding overload protection and the welder's ratings plate.
Cleaning and maintaining the wire feed unit and torch assembly.
Steps for replacing contact tips, drive rollers, and torch liners.
Cleaning and maintaining the gas cup.
Detailed guide to identifying and resolving common welding issues.
Guidelines for recycling and disposing of the product responsibly.
To Next Page
