Sears 113.298721, 113.298761 User Manual

Save This Manual For
Future Reference
OWBeTS
manual
MODEL NO'S.
113,298721
113.298761
SAW WITH LEGS
TWO CAST IRON
TABLE EXTENSIONS
MOTOR AND
QUICK RELEASE
RIP FENCE
Serial
Number
Model and serial number may be found
at the left-hand side of the base
You should record both model and
serial number in a safe place for future
use,
FOR
YOUR
SAFETY:
Read ALL
INSTRUCTIONS
CAREFULLY.
SE/ RS/C RR FTSM RN
10-INCH _BLE SAW
oassembly
. operating
orepair parts
Sold by SEARS, ROEBUCK AND CO., Chicago, IL. 60684 U.S.A.
Part No. SP5396
Printed in U.S.A.

Sears 113.298721, 113.298761 Specifications

General

Brand	Sears
Model	113.298721, 113.298761
Category	Saw
Language	English

Summary

SEARS/CRAFTSMAN 10-INCH TABLE SAW

Safety Instructions for Table Saw

Avoid Injury from Jams, Slips, or Thrown Pieces

Precautions to prevent kickbacks and other hazards during operation.

Whenever Saw Blade is Spinning

Critical warnings and procedures while the saw blade is in motion.

Motor Specifications and Electrical Requirements

Connecting to Power Source Outlet

Guidance on grounding the saw and connecting to power outlets.

Assembly

Aligning Rip Fence

Installing Blade Guard

Mounting the Motor

Getting to Know Your Saw

On-Off Switch

Description and operation of the saw's on-off switch.

Rip Fence

Identification and function of the rip fence.

Removing and Installing Sawblade

Procedure for safely removing and installing the sawblade.

Miter Gauge

Identification and function of the miter gauge.

Safety Instructions for Basic Saw Operations

Before Each Use

Essential safety checks and procedures before operating the saw.

Plan Your Cut to Avoid Kickbacks and Throwbacks

Strategies to prevent dangerous workpiece kickbacks during cuts.

Basic Saw Operation

Using the Miter Gauge

Instructions for performing crosscutting and miter cuts using the miter gauge.

Using the Rip Fence

Instructions for operations utilizing the rip fence for ripping and similar cuts.

Ripping

Explanation of how to perform rip cuts along the length of the workpiece.

Dadoing

Instructions for performing dado cuts using the dado head.

Adjustments

Blade Tilt, or Squareness of Blade to Table

Adjusting the blade tilt for squareness to the table surface.

Heeling Adjustment or Parallelism to Miter Gauge Groove

Ensuring sawblade parallelism to the miter gauge groove.

Maintenance

Trouble Shooting

Troubleshooting - General

Troubleshooting - Motor