--OPERATIONAN DADJUSTMENT
THE PERFORMANT LUBE TM WALKING BELT
Your treadmill features a walking belt coated with
PERFORMANT LUBE TM, a high-performance lubricant.
Dudng the first few hours of use, it is normal for a
small amount of white powder to appear on the foot
rails and the walking platform. The white powder Is ex-
cess high-performance lubdcant from the walking belt.
IMPORTANT: Never apply slllcone spray or other
substances to the walking belt or the walking plat-
form. They wlll deterlorate the walking belt and
cause excessive wear.
HOW TO PLUG IN THE POWER CORD
This product must be grounded. If it should malfunc-
tion or break down, grounding provides a path of least
resistance for electdc current to reduce the dsk of elec-
tric shock. This product Isequipped with a cord having
an equipment-grounding conductor and a grounding
plug. Plug the power cord Into a surge protector,
and plug the surge protector into an appropriate
outlet that Is properly Installed and grounded in
accordance with all local codes and ordinances.
This product isfor use on a nominal 120-volt cimuit,
and has a grounding plug that looks like the plug illus-
trated in drawing 1 below. A temporary adapter that
looks like the adapter illustrated in drawing 2 may be
used to connect the surge protector to a 2.-pole recap-
tacle as shown in drawing 2 if a properly grounded out-
let is not available.
The temporary adapter should be used only untila
propedy grounded outlet (drawing 1) can be installed
by a qualified electrician.
Your treadmill, like any other type of sophisticated
electronic equipment, can be seriously damaged by
sudden voltage
changes in your
home's power. Voltage
surges, spikes, and
noise interference can
resultfrom weather
conditions or from
other appliances being
fumed on or off. To '
decrease the possi-
bility of your tread-
mill being damaged,
always use a surge
protector (not In-
cluded) with your
treadmill
Surge protectors are
sold at electronics
stores and most de..
partment stores. Be
sure to read all instruc-
tionssupplied with
your surge protector.
The green-colored dgid ear, lug, or the like extending
from the adapter must be connected to a permanent
ground such as a properly grounded outlet box cover.
Whenever the adapter is used it must be held in place
bya metal screw. Some 2-pole receptacle outlet box
covers are not grounded. Contact a qualified elec-
trician to determine if the outlet box cover Is
grounded before using an adapter.
_Grounded Outlet Box
I _,J /Grounding Pin
'_rounding Plug
_Grounded Outlet
_,__. ,Grounded Outlet Box I
/Adapter I
/ ,_ __Grounding Pin
,
/'T_ _'r,_"_ "_ Grounding Plug
Metal __rew I
'Surge Protector
7
To Next Page
Loading...
