© 2017 SeaStar Solutions i7700 Shift & Throttle System User’s Manual, Rev. A
3-3
ENGINE TRIM CONTROL (OPTIONAL):
Provides simultaneous trim control of all engines.
LEVER POSITION
INDICATORS
INDICATOR DIMMING FEATURE:
When the control head is active, pressing
Take Command repeatedly will cycle through
five available indicator brightness levels.
NEUTRAL INDICATOR LAMPS:
These lamps have four states:
Steady green – engine is in neutral
Slow flashing green (0.5s on, 0.5s off) – Neutral
Throttle Warmup is engaged
Very slow flashing green (1s on, 2s off) – Trolling
Mode is engaged
Fast flashing red – A danger fault is active
See section 4.
TAKE COMMAND BUTTON AND LAMP:
Used to activate a control head.
To take command with a control head:
• Put control levers in neutral and press Take Command.
• The adjacent lamp signals the transfer status as follows:
Steady blue – station is active and in control of shift and throttle.
Flashing blue – station transfer from one station to another is
underway. You have five seconds to match the control lever positions
with those of the active station to complete the transfer.
Fast flashing blue – A warning fault is active. See section 4.
Lamp off – station is inactive
Note: If the lamp does not come on when you press Take Command,
Station Protection may be enabled. See section 3.3.4.
Figure 3-2.
To Next Page
Loading...
Need help?
General
