© 2017 SeaStar Solutions i7700 Shift & Throttle System User’s Manual, Rev. A
3-7
NEUTRAL THROTTLE WARMUP (NTW):
NTW allows you to control engine throttle without gear
engagement, so that you can warm up your engine at
a higher RPM. A slow flashing green neutral indicator
lamp tells you that NTW is engaged.
To engage Neutral Throttle Warmup:
• Move the control lever to the Neutral position. The
neutral indicator lamp will light steady green.
• Press the N button. The neutral indicator lamp will
flash green to indicate that NTW is engaged.
• You can now increase throttle and the engine will
stay in neutral.
To disengage Neutral Throttle Warmup:
• Return the lever to the Neutral position.
•
Press the N button. The lamp will light steady green.
The engine and transmission will now respond
normally to lever commands.
TROLLING MODE (TM):
• Provides greater throttle sensitivity: moving the control lever to full
forward will only produce a percentage of wide open throttle. The
default TM throttle limit is 50% in forward gear, 100% in reverse gear.
•
A very slow flashing (one second on, two seconds off) green neutral
indicator
lamp indicates that trolling mode is engaged.
TO ENGAGE Trolling Mode:
• Move the control lever to the forward idle or reverse idle
positions.
• Press the N button. The lamp will flash green slowly to indicate that
TM is engaged.
TO DISENGAGE Trolling Mode:
• Move the control lever to forward idle or reverse idle position.
• Press the N button. The flashing green lamp will go out to indicate
that TM is disengaged.
Figure 3-6.