Operation
Vehicles with analogue instrument panel
●
Press and hold the button
››› Fig. 123
4
for more than 5 seconds to
consult the service message
V
ehicl
es with digit
al instrument panel
●
The date of the service can only be read
through the Service menu ››› page 112.
Resetting service interval display
If the service was not carried out by a SEAT
dealership, the display can be reset as fol-
lows:
Vehicles with analogue instrument panel
●
Switch off the ignition, press and hold but-
ton
›
›› Fig. 123
4
.
●
Switch ignition back on.
●
Release the button and press it
again f
or the ne
xt 20 seconds.
V
ehicles with digital instrument panel
●
The service interval display can only be re-
set through the Service menu ››› page 112.
Do not restart the indicator between the
service intervals, otherwise the information
displayed will be incorrect.
If the oil change service is reset manually, the
service interval display changes to a fixed
service interval, also in vehicles with Flexible
oil change service.
Note
●
The service message disappears after a
fe
w seconds, when the engine is started or
when OK/RESET
is pressed on the wind-
screen wiper le
ver, or OK
on the multifunc-
tion steering wheel.
●
In vehicl
es with the LongLife system in
which the battery has been disconnected
for a long period of time, it is not possible to
calculate the date of the next service.
Therefore the service interval display may
not be correct. In this case, bear in mind the
maximum service intervals permitted
››› page 368.
●
If you reset the display manually, the next
service interval will be indicated as in vehi-
cles with fixed service intervals. For this
reason we recommend that the service in-
terval display be reset by a SEAT author-
ised Dealer.
Using the instrument panel
Intr
oduction
With the ignition switched on, it is possible to
r
ead the diff
er
ent functions of the display by
scrolling through the menus.
In vehicles with multifunction steering wheel,
the multifunction display can only be operat-
ed with the steering wheel buttons.
Some menu options can only be read when
the vehicle is at a standstill.
WARNING
Distracting the driver in any way can lead
to an accident and cause injuries.
●
Nev
er use the menus on the instrument
panel display while the vehicle is in motion.
Note
After loading or changing the 12-volt bat-
tery, check the system settings. If the po
w-
er supply is interrupted, the system settings
might be incorrect or deleted.
Operation with the windscreen wip-
er l
e
v
er
Fig. 132
Windscreen wipers lever: control but-
t
ons.
122
To Next Page
