The essentials
Securing the Top Tether* to the an-
chor
age point
Fig. 41 Retainer strap: adjustment and assem-
bly accor
ding t
o the T
op Tether belt.
Securing the retainer strap
●
Follow the manufacturer's instructions to
depl
oy the chil
d seat T
op Tether retainer
strap.
●
Place the belt under the head restraint of
the back seat
›››
Fig. 41 (depending on the in-
structions of the chair itself, lift or remove the
head restraint if necessary).
●
Slide the strap and secure it properly with
the anchorage of the backrest ››› Fig. 40.
●
Firmly tighten the strap following the manu-
facturer's instructions.
Releasing the retaining strap
●
Loosen the strap following the manufactur-
er's instructions.
●
Push the lock and release it from the an-
choring support.
›››
in Safety instructions on
page 83
Starting the vehicle
Ignition l
ock
Fig. 42
Ignition key positions.
Turn on the ignition: place the key in the igni-
tion and st
art the engine
.
L
ocking and unlocking the steering wheel
●
Lock the steering wheel: remove the key
from the ignition and turn the wheel until it
locks. Depending on the country, in vehicles
with automatic transmission, in order to re-
move the key, move the gear shift to the P po-
sition. If necessary, press the gear shift block-
ing key and release it.
●
Unlock the steering wheel: put the key into
the ignition and turn it at the same time as the
steering wheel in the direction indicated by
the arrow. If it is not possible to turn the steer-
ing wheel, it may be because it is locked.
32
To Next Page
