Wipe off any epoxy that squeezes out with some rubbing alcohol on a paper towel.
RADIO SET UP
Connect your 7-channel receiver to the servo wires as follow:
throttle = THROTTLE
aileron = AIL
to connect the 2 ailerons, use the “Y” included in hardware pack
elevator = ELE
rudder = RUDDER
here are factory connected toghter the 2 rudders and the thrust rudder axis
gear = GYRO SENS.
if your plane versions with gyro factory installed
aux 1 = VEKTOR 1
aux 2 = VEKTOR 2
To Next Page
Loading...
