Sebart Mig29 3D-EDF - Programming Mixes: MIX2 and MIX3; MIX2: Elevator to Vektor 1 Control; MIX3: Elevator to Vektor 2 Control

In Pos 0 (normal flight) this mixing need to be activated, ON.
In Pos 1 (full rates) this mixing need to be dis-activated, OFF.
In Pos 2 (3D & hovering) this mixing need to be dis-activated, OFF.
Full Aileron RIGHT & full Aileron LEFT → elevator DOWN 10%
This mixing will help to perform at normal and fast speed very axial rolls.
In Pos 0 (normal flight) this mixing need to be dis-activated, OFF.
In Pos 1 (full rates) this mixing need to be activated, ON.
In Pos 2 (3D & hovering) this mixing need to be activated, ON.
Full elevator UP → vektor 1 UP 100%
Full elevator DOWN → vektor 1 DOWN 100%
This mixing is necessary for the 3D flying.
In Pos 0 (normal flight) this mixing need to be dis-activated, OFF.