Page 6
A. Before turning on your brush machine, remove the machine from
the storage tray (7) by pressing down the catch (15) and lifting the
machine upwards by the handle (figure 1).
To replace the machine into the storage tray after use, first unplug the
machine, then lower the head onto the tray until the tray snaps into place
(figure 2).
Starting The Machine
B. Before turning on your brush machine, make sure that the storage
tray has been removed (see above) and that you have a firm hold on the
handle grip to keep the machine from moving forward.
1. Turn the quick release cable hook (14) to the up position
by moving it to the left or right.
2. Release the power cord plug from the power cord
and lift the cord (13) off of the upper cord hook.
3. With the switch (2) in the “O” (OFF) position, plug the
polarized power cord into a 120 volt outlet located
near the floor.
Switch Position
O = OFF
I= ON
Operating Instructions
Figure 1
Figure 2
15
7
13
14
2
To Next Page
Loading...
