Sebo duo - Using the duo Cleaning System; Deep Carpet Cleaning; Spot Stain Cleaning; Usage Tips and Precautions

Page 7
• For best results, vacuum carpet prior to applying duo-P powder.
• Check a small, inconspicuous area of the carpet for colorfastness.
• Absorb any moisture from carpet using white paper towels before applying duo-P
powder.
• Open window to speed drying.
• Reseal package after opening to maintain moisture. To ensure longer life of the
powder, seal all opened packages inside of a zip-lock bag.
• Only moist powder will effectively clean. If powder becomes dry before it is used
(e.g. powder left in an opened package), it will no longer work.
• Before using the SEBO duo-P Powder on your carpets, please read all instructions
and warnings provided with the powder and all the instructions and warnings in this
manual.
• Limited suitability for berber and needlepunch carpets.
• Use caution if cleaning berber or looped pile carpeting with the brushing
machine or when using the hand brushes.Test an inconspicuous area to
determine suitability. Do not used on hand-woven or dyed carpeting. Check
with the carpeting manufacturer for approved cleaning methods.
Important Product Tips:
First, vacuum your carpet prior to applying duo-P Powder. Then, spread duo-P Cleaning
Powder evenly over the carpet. This can be done by spreading the powder directly out of
the bag, or by spreading the powder by hand.Distribute the powder lightly, but evenly, over
the area to be cleaned (figure 1). You need not use an excessive amount of powder for
effective cleaning.
Work the powder into the carpet using the SEBO duo Brush Machine, which opens the
carpet pile enabling the duo-P powder to clean around each separate fiber (figure 2).
Once the duo-P powder has absorbed all of the dirt and the area is dry to the touch
(approximately 30 minutes), simply vacuum the area thoroughly (figure 5).
To Clean the Entire Carpet - Figures 1, 2 & 5
Figure 1
Figure 2
Figure 3
Figure 5
How to use the duo Cleaning System
Vacuum any loose dirt or debris from area. If soiled area is wet, use white paper towels to
absorb all moisture from the carpet. This will prevent the powder from “caking up” on the
carpet and the brush.Then, spread a small amount of duo-P powder onto the soiled area.
Gently work the powder into the carpet using the spot cleaning brush (page 5, #8), the
brush provided with the SEBO Clean Box (figure 3), or the the accessory brush (figure 4).
Older or more stubborn stains may require further treatments. Simply repeat the process
until the stain is completely removed.
Once the duo-P powder has absorbed all of the dirt and the area is dry to the touch
(approximately 30 minutes), simply vacuum the area thoroughly (figure 5).
To Spot Clean Stains - Figures 3, 4 & 5
Figure 4