Sebo duo - Machine Maintenance; Brush Removal and Cleaning; Brush Replacement; Troubleshooting

PROBLEM
Does not turn on
or machine shuts off
intermittently
REASON
1. Handle not fully inserted into the
housing, causing a faulty connection.
2. Not plugged into good outlet.
3. Cable worn.
4. Brush has not been reinserted
properly.
5. Defective switch.
SOLUTION
1. See page 5 for how to insert
handle.
2. Use another outlet.
3. Replace cable.
4. See page 8 for how to replace
brush.
5. Return to your authorized SEBO
dealer for repair.
Trouble-Shooting Guide
Always unplug brush machine from outlet before dismantling any part of the machine!
!
Page 8
Removing the Brushes to Change or Clean -
Figures 7 & 8
Remove the brushes (6), by unscrewing the two screws (17) at
the end of each brush from the bearing block (18). Do not
remove the screws that are recessed. Push the top of the brush
and the block forward at the same time. Take the block off the
brush, then, lift the brush upwards out of the brush housing.
Cleaning the Brushes
The brushes must be removed from the machine to be
thoroughly cleaned. See instructions above for removing the
brushes. Clean by running your SEBO vacuum’s suction hose,
with crevice tool attached, up and down each brush to remove
dirt and powder. Some carpet fibers, dirt and debris may
require removal by hand. Replace the brushes - see instruc-
tions below.
A cursory cleaning of the brushes may be done without remov-
ing them, by unplugging the machine, turning the brush rollers
upright, and using your vacuum’s suction hose, with crevice
tool attached, to remove the loose dirt or powder.
Replacing the Brushes - Figures 8 & 9
To replace each brush, insert the end with the slots into the
housing and locate the slots over the drive cog (19) by turning
the brush. Push the brush forward slightly to enable the bear-
ing block (18) to be replaced, then push the block back into
place in the brush housing and replace the two screws (17).
Figure 7
Figure 8
Figure 9
Always unplug brush machine from outlet
before dismantling any part of machine!
!
One Replacement Brush
Part #3005 ER
Maintenance
17
18
19
6