3.10.2 Change password by ID number
* ID number # old password # new password # new password #
Example, Change user’s password by ID number:* 1#123456#111111#111111#
Note: when change password by ID number, the old password can’t be initial password 1234.
3.11 Users to open the door
Swipe the valid card, or enter 6 digits user passwords, or press the Exit button.
Note: No need to press key # after entering the password, which reduced frequency use of key #
and greatly improved the lifetime of key#. When opening the door, there will be a long sound of
"beep" and the indicator light will turn into green. When the working mode is by card and
password, the time between swipe the card and input the password can’t wait to exceed 5
seconds.
3.12 Resetting To Factory Default Setting
When forget the administrator password, or the users randomly adjust various parameters, you can
reset to factory default setting by following below steps:
power off, press *and hold it, then power on, when hear two beeps Di Di ,then release *, the
administrator password is revert to 888888 successfully. Meanwhile all the parameters were resetted
to factory default mode shows in below “Administrator mode operation summary table”, the
user’s card and password won’t be deleted.
4 Administrator mode operation summary table
Enter into Administrator Operation Mode: *(6 digits master code) #
Menu
Parameters or operation
steps
Function Default
0
（new master code）#,
( new master code again)#
Modify
master
code
888888
1
read card,…,* Quickly add user card
(ID No.)#，swipe card,…,* Add user card by specifying ID No.
(ID No.)#,(user password)#,…,* Add user password by specify ID No.
2
Swipe card,…,* Quickly delete card
(ID No.)#,…,* Delete card or password with ID No.
0000#，* Delete all users
3
0# Entry by card only
2
1# Entry by card and password together
2# Entry by card or password
3# Entry by password only
To Next Page
Loading...
