3.5 Setting the working mode
3 0 # card only.
3 1 # card and password.
3 2 # card or password. This is factory default mode.
3 3 # password only.
Example, set the working mode to card and password: 3,1#.
3.6 Setting door relay time
4 0 # door relay time is 50ms. This is factory default.
4 (1-98) # the door relay time is set to 1-98 seconds.
4 99 # Set to switch mode, means the relay changes state every time when swipe a valid card
or password to open the door.
For example, set the relay time to 5 seconds: 4,5#.
Note: The 50ms is suitable for electric control lock or use special access control power supply.
The switch mode is suitable for normally open or normally closed door.
3.7 Setting the lock mode
5 0 # power-on unlock mode is the default mode , for electric lock etc. If use special access
control power supply, also should be set to this mode.
5 1 # is power-off unlock mode, such as electric bolt, magnetic lock, etc.
Example, set for electric bolt lock: 5,1#.
3.8 Setting the security mode
6 0 # Normal mode, this is the factory default mode
6 1 # Lock mode. When invalid card, invalid user password or invalid administrator password
is continuously tried 10 times, the access control will be automatically locked for 10 minutes.
Example, set the security mode to lock mode: 6,1#.
3.9 Exit from the administrator mode
Press key * several times under the administrator mode until the indicator light turns to normal red.
3.10 Change user’s password
3.10.1 Change password by card
* swipe user card Old password # New password # New password #
Example, Change user’s password by card：*，Swipe card 1234#123456#123456#
Note: When add a new user card, an initial password 1234 is automatically generated. 1234 can’t
be used to open the door, It can only be used to modify the user password. The new user
password can only be 6 digits.
3.4.3 Delete all users
2 0000 # *
Example, 20000#*
To Next Page
Loading...
