Hygiene treatment • 101
17-10-07-653-100_01-2020B
6. Confirm the prompt on the display with the key.
You exit the menu automatically.
The device will be reset to factory settings.
8. HYGIENE TREATMENT
WARNING!
Electric shock
The device is not de-energized when the display goes out. Use of
fluids on the device may cause electric shock.
► Disconnect the power supply connector before performing any
hygiene treatment.
► Ensure that no fluids penetrate the device.
NOTICE!
Damage to device
Inappropriate detergents and disinfectants may damage the sensitive
surfaces of the device.
► Use alcohol-based disinfectant (e.g. 70 % ethanol) exclusively.
► Do not use aggressive or abrasive cleaning agents.
► Ensure that no moisture or dust get into the sensors during
cleaning.
8.1 Cleaning
► Use a soft cloth dampened with mild soapsuds to clean the surfaces of
the device.
8.2 Disinfecting
1. Use an alcohol-based disinfectant (e.g. 70 % ethanol).
2. Follow the instructions on the disinfectant.
3. Disinfect the device:
► Moisten a soft cloth with disinfectant and wipe down the device with
it.
► Comply with the intervals, see table.
► Sterilizing
This device may not be sterilised.
Interval Component
Before every
measurement
Weighing platform
After every
measurement
Weighing platform
If required
• Multifunctional display
• Display cable
To Next Page
