What to do if no weight is displayed on Seca Scales with a load?
If no weight is displayed on your Seca Scales when there is a load, it may be because the scale has no power supply. Check whether the scale is switched on.
What to do if Seca Scales display "tEMP"?
If the display "tEMP" appears on your Seca Scales, it means the ambient temperature is too high or too low. Set up the scale in an ambient temperature between +10 °C and +40 °C and wait approximately 15 minutes for the device to adapt to the ambient temperature.
What to do if Seca Scales display "Er:X:11"?
If your Seca Scales show the display "Er:X:11", it means the scale has too high a load or too much load in one corner. Remove some of the load or distribute the weight more evenly, and then restart the scale.
What to do if Seca 676 Scales display "Er:X:12"?
If your Seca Scales show the display "Er:X:12", it indicates that the scale was switched on with too high a load. Remove the load from the scale and restart it.
What to do if Seca 676 Scales display "Er:X:16"?
If the display "Er:X:16" appears on your Seca Scales, it means the scale was caused to oscillate, and the zero point could not be determined. Restart the scale.
Why does 0.00 not appear before weighing on Seca 676 Scales?
If 0.00 does not appear on your Seca Scales before weighing, it means a load was already on the scale before it was switched on. Remove the load, switch the scale off, and then switch it back on again.
What to do if my Seca 676 Scales transmit results and beep after the first switch on?
After switching on your Seca Scales for the first time, if measurement results are transmitted and two beeps are heard, it could be due to these reasons: 1. The device was unable to send measurement results to the wireless receiver. Ensure that the scale is integrated into the wireless network and that the receiver is switched on. 2. Reception is being interfered with by HF equipment. Keep HF equipment at least 1 meter away from transmitters and receivers.
What to do if Seca 676 Scales display "Er:X:71" when pressing Enter key?
If the display "Er:X:71" appears on your Seca Scales when you press the Enter key, it indicates that data transmission is not possible because the wireless module is deactivated. Activate the wireless module.
What to do if Seca 676 Scales display "Er:X:72" when pressing Enter key?
If the display "Er:X:72" appears on your Seca Scales when you press the Enter key, it means data transmission is not possible because no wireless group is set up. Set up a wireless group.
Why is only the "SYS" item visible in the rf menu of my Seca 676?
If only the "SYS" item is visible in the rf menu of your Seca Scales, it means the wireless module is deactivated. Activate the wireless module.
Explains the scale's measurement capabilities, including unit switching and BMI calculation.
Provides fundamental safety guidelines for handling and using the device.
Identifies and describes the function of each control button and element on the scale.
Explains how to connect the power pack and establish a power supply for the scale.
Details the steps for moving, aligning, and preparing the scale for use.
Explains how to switch on the scale and perform a weighing procedure.
To Next Page
General
