Why are only the "SYS" and "lrn" items visible in the rf menu of my Seca 676?
If only the "SYS" and "lrn" items are visible in the rf menu of your Seca Scales, it means the wireless module is activated, but no wireless group is set up. Set up a wireless group.
Why are the items "APrt" and "Time" not visible in the rf menu of my Seca 676?
If the items "APrt" and "Time" are not visible in the rf menu of your Seca Scales, it indicates that no wireless printer is registered to the wireless group. Register the wireless printer to the wireless group via the "lrn" menu item.
What to do if one segment is illuminated continuously on Seca Scales?
If one segment is illuminated continuously or not at all on your Seca Scales, it means the corresponding point has a fault. Inform the service department.
What to do if the “rf” item is not displayed after calling up the menu on Seca 676 Scales?
If the “rf” item is not displayed after calling up the menu on your Seca Scales, it indicates that the scale’s wireless module is defective. Inform seca service.
Explains the scale's measurement capabilities, including unit switching and BMI calculation.
Provides fundamental safety guidelines for handling and using the device.
Identifies and describes the function of each control button and element on the scale.
Explains how to connect the power pack and establish a power supply for the scale.
Details the steps for moving, aligning, and preparing the scale for use.
Explains how to switch on the scale and perform a weighing procedure.
To Next Page
General
