Seca 878 - Power Supply Setup; Scale Setup and Alignment

10 •
4.2 Establishing power supply
Inserting battery You need 6 AA-type batteries, 1.5 V (scope of delivery).
1. Press on the latch of the battery compartment.
2. Fold down the cover of the battery compartment.
3. Take out the battery holder.
4. Put the batteries in the holder.
NOTE:
Ensure the correct polarity of the batteries (markings in the battery
holder). If the display
bAtt appears, you have inserted one of the
batteries the wrong way round or the batteries have discharged.
5. Place the holder containing the batteries in the battery compartment.
6. Close the battery compartment.
Connect the power supply unit
(optional)
The scale can be operated with a power supply unit (accessory).
WARNING!
Using the wrong power supply units may cause bodily injury or
damage to the device
Conventional power supply units may deliver a higher voltage than is
indicated on them. The scale may overheat, catch fire, melt or short-
circuit.
► Use only original seca plug-in power supply units with controlled 12
V output voltage.
1. Insert the plug required for your power supply into the power supply unit.
2. Insert the connector of the power supply unit into the connecting socket
of the scale.
3. Plug the power supply unit into a power supply socket.
4.3 Setting up and aligning scale
1. Place the scale on a firm surface.
2. Align the scale by turning the foot screws.
The air bubble in the spirit level must be located in the exact center of the
circle.
3. Ensure that only the feet of the scale are in contact with the ground. The
scale may not be in contact anywhere else.
NOTE:
The alignment of the base of the scale must be checked every time
the scale is moved and corrected if required.
Connection for power supply unit
Spirit level