Seca CT3000/P80 User Manual

How to Replace Your
Seca CT3000/P80 ECG Paper
Remove any remaining paper
Place the new pack of paper in the paper
tray and pull the paper to the right
Ensure the blank side is facing upwards
Flip the paper so it is positioned the to
the left
Ensure...
The printed (grid) side is facing up
The black markers are at the top
There is no thick red line visible on the
bottom of the paper
For service support please contact us on;
Tel: (01487) 843193 Email: service@imotek.com
For paper supplies please contact our sales department
Product code: MT165 Tel: (01487) 843193 Email: sales@imotek.com
IMOTEK International Ltd
Imotek House, West Newlands Ind. Estate, Somersham, Huntingdon, Cambridgeshire, PE28 3FF

Seca CT3000/P80 Specifications

General

Display	LCD
Printing	Optional Printer
Capacity	300 kg
Division/Weight Resolution	100 g
Power Supply	Battery or AC Power
Data Transmission	RS232 interface
Data Storage	Yes
Height Measurement Range	60 - 200 cm
Height Resolution	1 mm
Connectivity	USB

Summary

Seca CT3000/P80 ECG Paper Replacement Guide

Remove Remaining Paper

Remove any old or remaining ECG paper from the device before inserting new paper.

Insert and Orient New Paper

Place the new paper pack into the tray, pull it to the right, and ensure the blank side faces upwards.

Position Paper for Feeding

Flip the paper so it is positioned towards the left side of the device for correct feeding.

Final Paper Alignment Check

Verify printed side up, black markers at top, and no thick red line visible on the bottom.