4.3.1 SETTING ANALOG TIME
After battery replacement or Reset, users are required to set analog time to the current time
position manually. The succeeding analog time will be set by watch automatically whenever
digital time changes.
- When entering Hands SET setting, Row 2 will display AlignSecTo00. Second Hand will
move quickly to 00 and stop at position 00. If not, press S1 to align Second Hand to
position 00.
- Press S3/S4 to select below SET item, use S1/S2 to adjust SET item to current hand.
s position
(Hands SET setting) → SET AlignSecTo00 → SET MinuteHand → SET HourHand
- Press and hold S4 for 2 seconds for exiting setting mode. Upon exiting, Hands will move
quickly to the current digital time. (note: to avoid shock & swing during the alignment)
Row 2 will display count down time for analog hands to complete adjusting. If the waiting
time is less than moving time, hands will wait for the digital time to come.
Remark: If the setting mode is idle for 1 minute at any stage, the watch will automatically
return to Normal Time mode.
To Next Page
Loading...
