6.4.4.2 Set distance calibration
Option 2 allow user to input the Run distance, perform the run and let the watch calculate
the Factor value.
(Calibrate Distance) Manual Distance → Run Distance → Input Distance → Start →
Stop → auto Factor.
- In Calibrate Distance mode, use S3/S4 browse to Manual Distance mode
- In Manual Distance mode, use S1/S2 to select Run Distance mode
- In Run Distance mode, press S3/S4 to get to Input Distance mode
- In Input Distance mode, use S1/S2 to input the run distance then press S3 to Press Start
mode.
- In Press Start mode, press S1 when you start running. Press S1/S2 again to stop when
full distance completed. The watch will calculate automatically and display factor value in
2 seconds.
- Calibration Error will occur when the completed distance is less than 50% or greater than
150% of the input distance. In this case, press any key to return to Calibrate Distance mode
and restart.
Remarks:
Input Distance: min=100m, max=10km, default=400m
To Next Page
Loading...
