Warning software
hyperterminal is not the
part of the package! It is
also not a part of a
regular operating system
and must be additionally
installed. The
recommended software
are PuTTY, ZOC terminal
etc.
6) If you selected PuTTY,
the session options must
be same as the ones in
the device.
The important part is
COM port, which serves
for communication with
the terminal.
7) After clicking the Open
button, you reach the
console window. You can
now test the correct
connection using AT
commands AT and ATI.
The device responds with
OK and its Firmware
version.
CONNECTION TO PC VIA USB
1) Connect the USB cable to the terminal and to PC.
2) Install the drivers for your terminal.
If you do not have a driver in your disposal, you can request it at hotline@sectron.cz
3) In Windows OS, go to:
Start -> Control panels -> System -> Device manager.
4) This step depends on your device. The following example shows steps for
connecting to BGS5 terminal. The steps should still be similar with slight variations.
To Next Page
Loading...
