3.4.2 Overriding a schedule
1. If you perform a Boost operation, the running schedule will be overridden for the
duration until Boost persists.
2. If you modify the temperature set point while a schedule is running, the modified
change will persist only until the end of the running schedule period. At the start of
the next period, the settings will switch as scheduled.
3. If the Hold feature is applied, all schedule settings will be either on hold for the
duration specified or permanently stopped until hold is cancelled.
3.5 Summer mode
Switch to this mode if you want your heating to come on only when the temperature drops
below the pre-set frost protection temperature. (Default is 5 degrees but it can be changed
under Settings).
3.5.1 Applying the summer mode.
To apply summer mode, do the following:
1. Press the top menu button and navigate to the Summer mode menu (If required
press +/- until you reach the menu
2. Select the ENABLE SUMM MODE option and then confirm.
Note:
The DISABL SUMM MODE option will appear if Summer mode is already applied.
3.6 Warning
Warnings are important notifications that need your attention. These appear on the
homepage accompanied by a blinking symbol. Details of a certain warning can be
checked under the Warning menu. The description of some warning messages is given
below:
3.6.1 Understanding Warning messages
Indicates that the PTD service is due. This is a landlord
setting for Housing associations or local authorities only,
who should be contacted. Secure do not set or manage
this feature.
Note:
If the system is not serviced in time, you may not be able to
control your heating or only partial control will be available,
depending on the settings configured by your installer.
To Next Page
Loading...
Need help?
General
