Security Camera King PENDVR-EL8M4K - Page 250

486
Parameter
Function
Remote
channel No.
After getting the remote device channel amount, click Setup to select a
channel.
Note
Click to select one or more remote channel numbers here.
Channel
The local channel number you want to add. One channel name has
corresponding one channel number.
Decode buffer
There are three item: realtime,local, fluent.
Service type
There are four items: auto/TCP/UDP/MULTICAST(ONVIF device only)
Note
 The default connection mode is TCP if the connection protocol is
private.
 There are three items:TCP/UDP/MULTICAST if the connection protocol
is ONVIF.
 There are two items: TCP/UDP if the connection protocol is from the
third-party.
Step 3 Click Save button.
The newly added device is added to the list at the bottom of the interface.
Note
means connection successful. means connection failed.
5.10.1.1.4 Modify or Delete Device
 Click or double click a device in the added list. Device pops up the following
dialogue box. See Figure 5-29.