Section 15 -Data Field Descriptions
15–9
✱
72 BYPASS RESTORE REPORT CODE 0 | 0
See box on a previous page
.
This is sent when a zone that has been bypassed
is unbypassed.
✱
73 AC RESTORE REPORT CODE 0 | 0
This is sent when AC power has been restored after an AC power outage.
See
box on a previous page.
Reports with subscriber number.
✱
74 LOW BAT RESTORE REPORT CODE 1 | 0
This is sent when a system low-battery condition is restored to normal.
See
box on a previous page
.
Reports with subscriber number.
✱
75 RF XMTR LOW BATTERY RESTORE CODE 1 | 0
See box on a previous page
.
This is sent when a transmitter that previously
sent in a “Low Battery” message has sent a message indicating it no longer
has a low-battery condition.
✱
76 TEST RESTORE REPORT CODE 0 | 0
This is sent when the Test mode is exited.
See box on a previous page
.
Reports with subscriber number. A restore code entered here will cause a
“Restore” message to be sent when Test mode is exited.
✱80 OUTPUT DEVICES
Interactive menu mode applicable only if field
✱
25 is programmed for a 4229
or 4204, or if Powerline Carrier devices are being used.
Refer to Section 17: Output Device Programming for detailed procedure.
✱
81 ZONE LISTS FOR OUTPUT DEVICES
Interactive Menu mode applicable only if
✱
25 is programmed for a 4229 or
4204, or if Powerline Carrier devices are being used.
Refer to Section 18: Zone Lists for detailed procedure.
✱
82 CUSTOM ALPHA EDITING
Intera
ctive Menu mo
de used to program zone descriptors. (Also entered from
interactive field
✱
56.)
Refer to Section 19: Alpha Descriptor Programming for
✱
82 procedure.
To Next Page
Loading...