Verify BluTag Readiness
Prior to assignment, BluTag will regularly
call, acquire GPS, and note its battery level – allowing you to verify its readiness.
Installation
1. Click the Enrollees tile.
2. Select the enrollee’s profile.
3. Click the Device Assignments tab.
4. Click Change Assignment.
5. Type or select the desired device. A
green square indicates readiness.
6. If the status is not green, it has not met
one of the following criteria:
a. Recent contact
b. GPS of 60% or greater
c. Most recent battery level of 4 volts
or higher
7. If the above criteria has not been met,
click Contact to research its status.
44
1
2
4
5
3
7
To Next Page
Loading...
