SecurUS BLUtag - Page 46

Installation
9. Make note of BluTag’s serial number.
10. Place BluTag on the outside of the ankle
and wrap the strap around.
11. Insert two fingers inside the strap,
opposite the device.
12. Look for the line on the strap that is two
lines past the edge of BluTag.
13. Make a straight cut on the line, using
STOP cutters only.
14. Insert the unclipped end into the wing to
test the fit. Cut excess strap, if
necessary.
15. Attach clips to the end of the strap and
press firmly into the wing. Firmly pull the
strap to check the fit.
46
Attach BluTag to Enrollee (continued)
13
10 / 11
9
12
14
15