14
Setup
3. Press OKSTOP ULTRA-D
PLAYBACK.
4. Press OK to return to Real Time Conversion mode.
If the system does not recognize any of pre-converted Ultra-D content,
Conversion mode.
function cycles from the beginning. It will continue to loop through all
exit Load & Play mode.
NOTE:
Only one USB storage device may be connected at a time.
Multiple devices are not supported and may result in a system
error. To correct this issue, remove all USB devices from the
display and only re-plug a single USB device.
Certain USB device brands may not exhibit expected results--
unplugging them does not exit Load & Play mode. A message
“Unfortunately, seeCube has stopped” may display. When a USB
device is not functioning, discontinue use of that USB device and
replace it.
To Next Page
Loading...
Need help?
General
