Sega GRID Racing DELUXE - TROUBLESHOOTING

LAMPS AND LIGHTING
13
91
4
Once all four (4) xings have been removed, carefully release the Cathode Housing and disconnect the
power connector. (YEL/WHT).
5
Disconnect the Lamp Connector at the opposite side of the inverter, then release both clamps positioned at
each end of the cathode lamp..
6
Remove the Cathode lamp by sliding it carefully out of the housing via the access at one end. Replace the
bulb with one matching the specication stated , then reassemble the Unit in the reverse order.
Power Connector
Lamp Connector
Release clamps
Lamp access