Specification changes (removal of equipment, conversion and addition) not designated by SEGA are not
allowed.
The parts of the product include warning labels for safety, covers for personal protection, etc. It is very hazard-
ous to operate the product by removing parts and or modifying the circuits. Should doors, lids and protective
parts be damaged or lost, refrain from operating the product, and contact where the product was purchased from
or the office herein stated. SEGA shall not be held responsible for any accidents, compensation for damage to a
third party, resulting from the specifications not designated by SEGA.
Ensure that the product meets the requirements of appropriate Electrical Specifications.
Before installing the product, check for Electrical Specifications. SEGA products have a nameplate on which
Electrical Specifications are described. Ensure that the product is compatible with the power supply voltage and
frequency requirements of the location. Using any Electrical Specifications different from the designated Speci-
fications can cause a fire and electric shock.
Install and operate the product in places where appropriate lighting is available, allowing warning labels
to be clearly read.
To ensure safety for the customers, labels and printed instructions describing potentially hazardous situation
are applied to places where accidents can be caused. Ensure that where the product is operated has sufficient
lighting allowing the warnings to be read. If any label is peeled off, apply it again immediately. Please place an
order with where the product was purchased from or the office herein stated.
When handling the Monitor, be very careful. (Applies only to the product w/monitor.)
Some of the monitor (TV) parts are subject to high tension voltage. Even after running off power, some por-
tions are still subject to high tension voltage sometimes. Monitor repair and replacement should be performed
only be those technical personnel who have knowledge of electricity and technical expertise.
Be sure to adjust the monitor (projector) properly. (Applies only to the product w/monitor.)
Do not operate the product leaving on-screen flickering or blurring as it is. Using the product with the monitor
not properly adjusted may cause dizziness or a headache to an operator, a player, or the customers.
When transporting or reselling this product, be sure to attach this manual to the product.
In the case where commercially available monitors and printers are used in this product, only the contents relat-
ing to this product are explained herein. Some commercially available equipment has functions and reactions
not stated in this manual. Read this manual together with the specific Instruction Manual of such equipment.
Descriptions herein contained may be subject to improvement changes without notice.
The contents described herein are fully prepared with due care. However, should any question arise or errors be
found, please contact SEGA.
•
•
INSPECTIONS IMMEDIATELY AFTER TRANSPORTING THE PRODUCT TO THE LOCATION.
Normally, at the time of shipment, SEGA products are in a status allowing for usage immediately after trans-
porting to the location. Nevertheless, an irregular situation may occur during transportation. Before turning on
power, check the following points to ensure that the product has been transported in a satisfactory status.
Are there any dented portions or defects (cuts, etc.) on the external surfaces of the cabinet?
Are Casters and Adjusters, damaged?
Do the power supply voltage and frequency requirements meet with those of the location?
Are all wiring connectors correctly and securely connected? Unless connected in the correct direction, connector
connections can not be made accurately. Do not insert connectors forcibly.
Do power cords have cuts and dents?
Do the fuses used meet specified rating? Is the Circuit Protector in an energized status?
Are all accessories available?
Can all Doors and Lids be opened with the
Accessory keys? Can Doors and Lids be firmly closed?
To Next Page
Loading...
Need help?
General
