58
www.sauservice.com
E. SOUND TEST
Use SOUND TEST to test sound output and to select the stereo/mono/surround setting.
● Use the SERVICE Button to move the cursor to the desired test item.
● Press the TEST Button to enter the selected item.
(A)
OUTPUT TYPE(STEREO, MONO, SURROUND)
Select the sound output from the I/O PANEL audio output interface setting among
STEREO, MONO and SURROUND.
(B)
RIGHT/LEFT SPEAKER(ON, OFF)
When set to "ON", the test sends a beep to each audio output interface. Only the word
"SPEAKER" is displayed when the OUTPUT TYPE is set to "MONO", and when set to
"ON", the test sends the same beep to both the left/right audio output interfaces.
To test surround output, it is necessary to use a separate Audio Amp, and receive signal
from a terminal not in use at the time of shipping.
Note: Not available with this product.
● Move the cursor to EXIT and press the TEST Button to return to the SYSTEM MENU screen.
SOUND TEST
OUTPUT TYPE STEREO
RIGHT SPEAKER OFF
LEFT SPEAKER OFF
→EXIT
SELECT WITH SERVICE BUTTON
AND PRESS TEST BUTTON
(A)
(B)
(B)
To Next Page
Loading...
Need help?
General
