12-1 BILLBOARD FLUORESCENT LIGHT (52”/62”DX)
1) Turn the power off.
2) Use the enclosed Tamper screws wrench (L-wrench) to remove the 5 washers
and screws. The screws use a design washer. Make sure you do not lose these
parts.
3) Remove the billboard plate. The bottom of the billboard plate is inserted into
the cabinet. Lift it diagonally upwards to remove it.
4) Change the fl uorescent light.
FLUORESCENT LIGHT 48" 40W
PHOTO 12.1d
Tamper
screw
12-2 HOLSTER FLUORESCENT LIGHT
The lighting units on the front right and left sides of the HOLSTERS use a fl uorescent light.
1) Turn the power off.
2) Take off 4 screws to open the back plate of holster.
BACK PLATE
PHOTO 12.2a
PHOTO 12.2b
FL LAM
P
STARTER
BALLAST
9" 5WATT
DESIGN WASHER
CTF-1002
PHOTO 12.1b
PHOTO 12.1c
HEXAGONAL SCREW (5)
PHOTO 12.1a
37
Tamper screw & Washers (5)
To Next Page
Loading...
