Error 37
DISPLAY Verifying Game Program Failed.
CAUSE The program image is unverifi ed due to the program image not existing on the game disk or server.
COUNTERMEASURES Check that the correct game disk is inserted.
Error 41
DISPLAY Server Not Respond.
CAUSE The server is not responding.
COUNTERMEASURES Check the network settings. Set IP Address and other settings. Check that the network cable has not been pulled out.
Error 42
DISPLAY Server Mount Failed
CAUSE The server directory is could not be reached.
COUNTERMEASURES Check the network settings. Set IP Address and other settings. Check that the network cable has not been pulled out.
Error 43
DISPLAY IP Address Not Assigned.
CAUSE An IP Address could not be obtained from the DHCP server.
COUNTERMEASURES Check the network settings. Set IP Address and other settings. Check that the network cable has not been pulled out.
Error 44
DISPLAY Game Program Not Found on Server.
CAUSE No program image on the network server.
COUNTERMEASURES Check that the game title, place on the network server, and the key chip correspond to each other.
Caution 51
DISPLAY Wrong Resolution Setting.
CAUSE The game does not support the current resolution settings.
COUNTERMEASURES Change the DIP SW to the correct settings and restart.
Caution 52
DISPLAY Wrong Horizontal/Vertical Setting.
CAUSE The monitor horizontal/vertical settings are incorrect.
COUNTERMEASURES Change the DIP SW to the correct settings and restart.
14-3 REPLACING THE FUSE
Fuse replacements other than those specifi ed can cause accidents and are strictly forbidden. In case fuse replacements other than those
stated in this manual are necessary, contact where you purchased the product from for inquiries regarding this matter.
To prevent accidents due to electrical shock, always turn the power off and disconnect the power plug from the power outlet before performing
any task that involves touching the interior of the product.
Be careful not to damage the wires. Damaged wires may cause electric shock, short circuit or present a risk of fi re.
Be sure to use fuses meeting the specifi ed rating. Using fuses exceeding the specifi ed rating can cause fi re and electric shock accidents.
After eliminating the cause of a blown fuse, replace the fuse.
Depending on the cause of the fuse blow, continued use with the blown fuse can cause generation of heat and present a risk of fi re.
The Control Unit (Gun) circuit fuses are found, from facing the cabinet, inside side door R on
the right side of the cabinet. There are four fuses arranged vertically on the control panel inside
side door R. From top to bottom these fuses are -
- Player 1 Control Unit (Gun) speed sensor fuse
- Player 2 Control Unit (Gun) speed sensor fuse
- Player 1 Control Unit (Gun) targeting sensor unit fuse
- Player 2 Control Unit (Gun) targeting sensor unit fuse
1) Turn the power off.
2) Remove the three truss screws on side door R.
3) Unlock and remove side door R.
4) Exchange the fuse.
SCREW (4), black
PHOTO 14.3a
PHOTO 14.3b
FUSE 0.2A, 250V
PHOTO 14.3c
45
To Next Page
Loading...
