Homepage
After mapping, you will come to the Homepage, where you can view the entire work area, the status of the mower, and the work progress
(percentage and actual area), and remotely control the mower to start, pause or return to the charging station. Settings and Notification
pages can also be accessed from here.
Battery level Battery level and charging status
Lock status Mower locked. Unlock the mower before any operation. See how to enter PIN code in 3.1
Bluetooth Bluetooth connected. When disconnected, tap to reconnect
Connectivity Connects to internet (Wi-Fi or 4G)
Mower status Displays the current status of the mower
Notications Notifications from the device & app
Settings Settings of the mower and the app
VisionFence VisionFence sensor status
Check the signal
After the map is saved, satellite signal strength across the whole map will be measured and displayed. You can check or adjust the
position of the charging station according to the tips in the app so that the mower can perform better.
To check the signal distribution of the newly created map, you need to tap the signal icon in the upper right corner in the Navimow app.
You can also tap "How to check" for further guidance and advice.
NOTES:
1. You can review the signal distribution map at any time in Map management.
2. The signal distribution map only reflects the state of the satellite signal at the time the map data was recorded.
TEST
How to check?
MOW STOP
170
㎡
64
%
Coverage Progress
35
To Next Page
Loading...
