4.5 Power Supply
Disconnect the power supply:
- Before clearing a blockage;
- Before checking, cleaning or working on the machine;
- After striking a foreign object to inspect the machine for damage.
Regularly examine the cord, plug, enclosure and other parts. If any damage or signs of aging are found, stop using immediately.
WARNING
DO NOT operate a damaged power supply. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard. If the extension cable is defective, please replace it with the 10-meter (32.8-feet)
long cable as approved by Segway.
DO NOT connect a damaged cord to the power supply or touch a damaged cord or extension cable before it is disconnected
from the power socket. Damaged cords can lead to contact with live parts.
DO NOT use the power supply with any other product or battery, otherwise there will be risks of personal injury, fire or electrical
shock. Product safety cannot be guaranteed with other than original batteries.
DO NOT charge when the battery is leaking.
Keep the extension cable away from moving hazardous parts to avoid damage to the cords which can lead to contact with live
parts.
Recommendation
Connect the mower and/or its peripherals only to a supply circuit protected by a residual current device (RCD) with a tripping
current of not more than 30 mA.
4.6 Storage
Before storage, power off the mower and charge its battery to 85% or higher to avoid over-discharge, which will cause
permanent damage.
Store in a cool and dry place indoors. Exposure to sunlight and temperature extremes (both hot and cold) will accelerate the
aging process of the components and may permanently damage the battery.
Keep the mower, charging station and power supply away from heat sources (such as stoves, radiators, etc.) or chemicals.
Protect the power supply from moisture and keep it in a well-ventilated place.
WARNING
When there is a risk of a thunderstorm, unplug the power supply from the power socket. Disconnect all cables and wires
connecting to the charging station. Reconnect when there is no longer a risk of thunder.
Extra requirements for winter storage
The mower
Clean the mower thoroughly before storage. Check the components subject to wear such as the blades. Repair or replace them
if they are in poor condition. Store the mower in a dry and frost-free place, while standing on all wheels, preferably in the
original packaging.
The charging station and GNSS antenna
Unplug the power supply from the power socket and disconnect it from the charging station. Disconnect the GNSS antenna
from the charging station and take it down from the standing pole or the antenna extension kit. Keep the charging station and
GNSS antenna indoors and out of direct sunlight.
For more information, visit https://navimow.zendesk.com/hc/en-001/articles/11039122526489
53
To Next Page
Loading...
