Power Button
Turn ON/OFF. The Segway S-PLUS will automatically power OFF when idle for 10 minutes, or when laid
down (horizontal) for over 30 seconds.
Lock
Enable Lock Mode via the App. The Segway S-PLUS and app will vibrate and sound an alarm if anyone
moves it. The remote control will also alarm if it is powered on and within range (65 ft. [20 meters]) of the
Segway S-PLUS.
Bluetooth
When the App is connected to the Segway S-PLUS, this icon will glow steadily. When Bluetooth is enabled
—but not connected to a smart phone—this icon will blink
Speed Limit
Enable and adjust Speed Limit Mode via the App. When the icon is illuminated, Speed Limit Mode is on.
This speed limit can be adjusted in the App. As you approach the speed limit, the Segway S-PLUS tilts
back. When you reach the speed limit, the Segway S-PLUS beeps.
Power Level
Indicates the remaining battery life. Each block equates to approximately 20% power level. When the
battery is nearly empty this icon blinks and the Segway S-PLUS beeps, indicating that you need to charge
your Segway S-PLUS. Your Segway S-PLUS will gradually reduce the max speed limit as the power level
gradually decreases. When less than 10%, the speed will be limited to 6.2 mph (10 km/h). Use the App to
view the remaining power and estimated remaining range.
Remote Control
1. Power switch. Short press the Home button to power on the remote control. Long press to turn it off. The remote control will turn
off when idle for two minutes.
2. Home mode. Short press the Home button to tell your Segway S-PLUS to hold position.
3. Remote control battery indicator light.
To Next Page
Loading...
