Home
> 20% power Blue Charging Red, Breathing
< 20% power Red Fully Charged Blue
< 10% power Red, Blinking
< 5% power The remote control powers off automatically
Joystick
1. Move the joystick to turn on Remote Control Mode. Use the App to adjust the maximum vehicle
speed.
Follow
1. Short press the Follow Mode button to enable/disable Follow Mode. Use the App to adjust the
following speed and distance (from vehicle to controller).
2. Long press (1 sec) the Follow Mode Button to use the joystick to control the pitch and yaw position of
the attached camera
Camera
1. With the App, you can customize what this button does. By default it enables/disables Lock Mode.
2. When a camera is detected, short press the Camera Mode button to take a photo. Long press (1 sec)
to start recording video, and then short press to stop recording. The button blinks blue while recording.
Refer to the camera instructions for more information
When using the remote control, do not shield the antenna area; do not cover the antenna area with any part of your body. Turn off the
remote control and stow it in the storage compartment when not in use. Please note that the remote control cannot control the
movement of your Segway S-PLUS when in Riding Mode.
WARNING!
The remote control contains a Li-ion battery. Follow all instructions in this document and on the device label. Otherwise you risk
personal injury or property damage due to fire, explosion, electric shock, and other dangers.
Not user serviceable. To replace the battery, contact Segway (page 21).
Only use a Ninebot or Segway approved charge cable. Please use it properly within the rated range.
Always use a power supply that meets SELV and IEC60950-1 Limited Power Source requirements.
Assembling Your Segway S-PLUS
1. Slide the steering bar onto to the mounting bracket. Route the cable through the hole.
2. Align the tab on one connector with the notch on the other. Connect the cables.
To Next Page
Loading...
