108
Service Procedures (cont.)
Remove the i2 SE Tire/Wheel Assembly
Tools Required: 13 mm socket wrench
To remove the i2 SE Tire/Wheel assembly:
1. Make sure the Segway PT is unplugged and powered off.
2. Tip the PT on its side so the Wheel you want to remove is facing up,
and the bottom wheel rests against a smooth, clean surface.
3. Remove the Wheel Cap by pressing down on the outside edge and
lifting the opposite edge with a plastic wedge or screwdriver.
4. Remove the three Wheel Nuts with a 13 mm socket wrench. Hold
the Wheel to keep it from rotating.
5. Lift off the Wheel.
6. Clean all debris from the Wheel's mounting surfaces.
Wheel Cap
Figure 68: Remove the Tire/Wheel Assembly
To Next Page
Loading...
