EasyManua.ls Logo

Seiko 8X53 - TROUBLESHOOTING: INDICATOR HAND AND OPERATION; Indicator Hand Misalignment

Seiko 8X53
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
55
ASTRON 8X53 GPS SOLAR
          
TROUBLESHOOTING
CONTENTS
7
At trouble Possible causes Solutions
Reference
pages
Indicator hand
misalignment
The position of the hand
showing the reception
way, charging status, in-
flight mode ( ), and DST
is misaligned
The automatic leap second reception
function has been activated.
(The indicator hand displays as shown at
the right.)
It takes up to 18 minutes to complete the leap second reception.
Use the watch with reference to the “Place where GPS signals can be easily
received P. 1 6 .”
P. 29
The preliminary position of the indicator hand is
misaligned.
This occurs when the preliminary position of the
indicator hand is misaligned due to external factors or
system reset.
Adjust the preliminary position of the indicator hand to the
correct position.
P. 45 ~ 48
Operation
The crown or buttons
cannot be operated.
The stored electric power is running short. Sufficiently charge the watch until it starts moving at 1-small second intervals.
P. 1 4
Date is moving right after a setting is carried out by the
crown or button operation.
Wait without doing anything.
After the date stops, the crown and buttons can be operated.
You get lost in the middle
of the operation.
———
When the crown is pulled out
Push the crown back in.
The second hand will start to move within 6 minutes.
After that, restart operation.
When the crown is not pulled out
Press Button B.
The second hand will start to move within 2 minutes.
After that, restart operation.
Other
trouble
Blur on the dial glass
persists.
Small amount of water has got inside the watch due to
deterioration of the gasket, etc.
Contact the retailer from whom the watch was purchased.

Table of Contents

Related product manuals