3. Slide the band to the right and left and at an
appropriate length, push the pins firmly into
the adjustment holes again at those 2
locations.
* The above illustrations are provided as examples. Some details may differ depending on the model.
EN
64
6
TO PRESERVE THE QUALITY OF YOUR
WATCH
How to use an easy adjust type clasp
Some bands are provided with an easy adjust type clasp for fine adjustment of the band’s length.
If the clasp of the watch you purchased is as follows, please refer to the following instructions.
* The band can be lengthened by up to about 5 mm.
This is useful if the band feels too tight or is uncomfortable for some reason.
EN
65
6
TO PRESERVE THE QUALITY OF YOUR
WATCH
●
How to wear the band (Opening and closing the clasp)
Push button Buckle
1. Lightly press the push buttons to open the
clasp.
* Note that pressing the push buttons too
firmly (deeply) actuates the adjuster, which
lengthens the band.
2. Fasten the clasp by pressing the frame of
the buckle.
EN
66
6
TO PRESERVE THE QUALITY OF YOUR
WATCH
●
How to adjust the length of the band
1. You can lengthen the band by up to about 5 mm
(2 stages) by firmly pressing the push buttons
from both sides to actuate the adjuster.
2. Fasten the clasp by pressing the frame of the
buckle.
* Even while the clasp is closed, you can still retract
the length of band extended by the adjuster.
* The above illustrations are provided as examples. Some details may differ depending on the model.
EN
67
6
TO PRESERVE THE QUALITY OF YOUR
WATCH
To Next Page
Loading...
