32
Bluetooth Interface
1. Turn on the printer and pair it with the host device.
In the factory shipment state, the printer enters pairing mode for about 60 seconds by pushing the
power switch for 7 seconds or more. When the pairing mode starts, the POWER LED blinks in
green 5 times per second. During this time, pair the printer with the host device.
In the factory shipment state, pairing is conducted by SSP (Simple Secure Pairing). However, PIN
code is used when the host device does not support SSP, or Security Mode in the Function Settings
is set to PIN. The PIN code is "0000" at the shipping.
2. Conduct Bluetooth connection with the host device.
3. Check the communication status on the host device.
4. Send data from the host device, and verify that the data is printed correctly.
WARNING
◆
The printer may affect medical or other electronic devices. Obtain information and
data concerning influence due to radio interference from the respective manufacturers
or dealers.
◆
When using the printer in medical institutions, follow their guidelines.
◆
DO NOT use the printer in any area or district where its use is prohibited.
HINT
•
The distance of communication is approximately 10 m. However, the distance may differ
depending on the radio interference and environment.
To Next Page
Loading...
Need help?
General
