34
14. ATTACHING CRADLE
The cradle for using the printer as a stand-alone type or using as the charging stand can be attached to
this printer.
The cradle is an optional accessory. See "18. SPECIFICATIONS" and "19. ACCESSORIES AND
CONSUMABLE PARTS", and be sure to purchase our specified products listed on these references.
NOTE
◆
Be sure to fix the printer to the cradle when using the printer as a stand-alone type.
When using the cradle only as the charging stand of the printer, it is no need to fix the
printer to the cradle with the screw.
Each Part of Cradle
Figure 14-1 Each Part of Cradle (CDL-B01K-1)
1 USB connector
The USB cable is connected to here.
2 Charging terminal
When setting the printer, this charging terminal is connected to the charging terminal of the printer.
3 Spacer
The spacer is used for fixing the printer to the cradle with the screw when using the printer as a
stand-alone type.
4 Screw
The screw is used for fixing the printer to the cradle with the spacer when using the printer as a
stand-alone type.
To Next Page
Loading...
Need help?
General
