Seitron freetime evo - Page 9

TCD02B0001SE 034070 130220
9
CLOCK SETTING
In order to set the clock of the programmable thermostat follow the instructions below:
1. Open the flap which gives access to the buttons.
2. Push for at least 2 seconds the button “ “; the display shows “Set CLO” and the hour digits blink.
3. Set the hours by rotating the knob (right=Increase / left=Decrease).
4. Conrm with “ “ or by pushing the knob; the minutes digits blink.
5. Set the minutes by rotating the knob (right=Increase / left=Decrease).
6. Conrm with “ “ or by pushing the knob.
HEATING / COOLING SETTING
See the parameter “H_C” on the section “SETTING USER PARAMETERS”.
COMFORT TEMPERATURE SETTING
In order to set the Comfort temperature, follow this procedure:
1. Open the flap which gives access to the buttons.
2. Push the button “ “.
3. Rotate the knob, to adjust the regulation temperature (Set-point).
4. Conrm the set value with “
“ or pushing the knob.
ECONOMY TEMPERATURE SETTING
In order to set the Economy temperature, follow this procedure:
1. Open the flap which gives access to the buttons.
2. Push the button “
“.
3. Rotate the knob, to adjust the regulation temperature (Set-point).
4. Conrm the set value with “ “ or pushing the knob.
WARNING
Normally, in order to get a temperature decrease, the Economy
temperature must be set to a lower value than the Comfort
temperature.
DAILY TIME PROGRAM SETTING
During normal operation the upper and lower segments strip of the display shows the regulation mode of the freetime evo, which allows to customize
the daily time program according to each proper need.
The upper segments strip shows the temperature regulation on Comfort mode, while the lower one shows the temperature regulation on Economy.
The default time program is shown below:
The arrow, placed near the
comfort Set-point temperature,
blinks indicating the edit mode.
This is the room temperature value
detected by the internal / remote
sensor.
The arrow, placed near the
economy Set-point temperature,
blinks indicating the edit mode.
This is the room temperature value
detected by the internal / remote
sensor.
FACTORY SETTINGS (DEFAULT)
TIME SLOT REGULATION MODE
00:00 .. 06:00 Economy
06:00 .. 09:00 Comfort
09:00 .. 16:00 Economy
16:00 .. 22:00 Comfort
22:00 .. 24:00 Economy