Sekonic SPECTROMASTER C-800 - Safety Precautions; Before Use

★
If Dark Calibration Position Conrmation screen appears, set the Light Selection
Ring
❷
to Dark Calibration position and perform calibration again.
*
If "Please set Light Selection Ring for dark
calibration" is displayed, set the Light
Selection Ring
❷
to the dark calibration
position to start calibration.
*
When taking measurements, set the Light
Selection Ring
❷
to the range L (icon at
the middle) for ALL ambient light.
For flash light, set the ring to "H" (icon
at the top) high-power (brighter than
640lx·s) ash or "L" (icon at the middle)
for low-power ash (lower than 640lx·s).
Dark Calibration Position
Confirmation Screen
NOTE
Dark calibration is performed when new batteries are used, 24 hours passed
since last use or there is a big change in temperature between turning power
OFF and ON.
Except the cases above, dark calibration after power ON is skipped.
5. Measuring Mode and Display Mode
You can change screens after turning the power on as follows.
Changes from the Measuring screen to each screen.
★
Pressing Menu Button
❻
shifts to the Display Mode Selection screen.
Please set Light Selection
Ring for dark calibration.
[
Measuring Mode
Selection Screen
]
[
Display Mode
Selection Screen
]
1 3
64
97
2
5
8
󱧃󱧁 󱧂
[Measuring
Screen
(Text Mode)
]