To Next PageTo Next Page
Need help?Do you have a question about the Selden RB and is the answer not in the manual?
Steps to adjust the luff extrusion tension before mast stepping.
Procedures for unfurling, furling, and reefing the sail.
Instructions for operating the system from the cockpit and at the mast.
Step-by-step instructions for fitting and hoisting the mainsail.
Checks and procedures to perform before setting sail.
Using the integral luff-groove for a spare mainsail.
Purpose and function of the anti-vibration strip.
Recommended sail dimensions and luff groove compatibility.
Annual greasing of bearings and gears for the furling system.
Dismantling and thorough servicing of the gear for cleaning and re-greasing.
Steps to remove the furling mast gear from the mast.
Tools and procedures for dismantling the in-mast furling mast gear.
Procedure for dismantling the halyard swivel assembly.
Procedure for dismantling the top swivel assembly.
General| Length | Varies by model |
|---|---|
| Diameter | Varies by model |
| Weight | Varies by model |
| Finish | Anodized |
| Manufacturer | Selden Mast AB |
| Material | Aluminum |
