Product description
Seldén Mast in-mast furling mast is a mainsail reefing and furling system.
The furling geer has been developed from experience gained from FURLEX foresail roller-reefing, and is
dimensioned for the toughest conditions.
The unique design of the halyard swivel bearing distributes the load over the whole ball-race to give
smoother furling and the lowest possible friction.
The entire reefing mechanism can be easily removed from the mast for service. Stainless steel thread inserts
are used for all screws, so that dismantling is easy even after many years usage in a corrosive environment.
The mast extrusion has an additional luff groove for a storm trysail or spare main. A foresail with rope luff
could be hoisted.
This Instruction Manual has been compiled to give you information on the in-mast reefing system. Study it
and follow the instructions carefully, and we guarantee you many years of pleasurable use from your Seldén
Mast in-mast furling mast.
Follow the relevant rigging instructions in our booklet ”HINTS AND ADVICE” for tuning the rig.
Asymmetric luff extrusion giving reduced initial resistance to reefing due to easier bending of the luff.
Sail compartment
Fig. 2:1
Cable conduits
To Next Page
Loading...