SelectBlinds CORDLESS - HOLD DOWN BRACKETS (OPTIONAL); SHADE REMOVAL; HEAD RAIL; FASCIA OR NO HEAD RAIL

6
HOLD DOWN BRACKETS (OPTIONAL)
Optional hold down brackets are mounted with the supplied
screws.
With the shade at its proper drop, place the pin of each hold
down into the hole in each end cap and mark the screw holes.
Make sure the pins are level and aligned.
Raise the shade, then screw the hold down bracket into the
mounting surface.
SHADE REMOVAL
HEAD RAIL
Partially lower the shade and insert a at head screwdriver as
shown.
Twist the screwdriver until the head rail disengages from the
bracket.
As you release the brackets, support the head rail to keep it
from falling.
FASCIA OR NO HEAD RAIL
Rotate the T-hook on the support bracket. Li the post up and
o the support bracket.
CLEANING AND CARE
e shade fabric is easy to care for. Regular dusting with a feather duster or vacuum cleaner brush is recommended. Most
stains can be blotted with a damp sponge and mild detergent. Before using anything stronger than mild detergent and
lukewarm water, test an unobtrusive corner of the shade. If you have any questions, call your dealer for advice.